N.M.ELECTRONICS

            Automatic foot dust cleaner is an electronic project, which helps to clean the wastes from the foot. The microcontroller can be used here for trip on the relay to enable/disable the motor at our desired time. The key is used for gives the input to the microcontroller.

            It consists of various sections for efficient handling

§  Microcontroller

§  DC motor with driver unit

§  Relay section

§  Foot dust cleaning arrangement

            When the key is pressed, its input goes through the microcontroller; the microcontroller takes to control the relay action. The relay is activated by very few transistor controlled voltage but it provides the voltage depend on the motor driving from the uncontrolled supply voltage. The motor can work efficiently by the way of switching relay.

            Finally, the motor activates the foot dust cleaner. Depends upon the motor speed the dust can be removing cleanly. This device does not come to the foot present area; we should put our dirty foot at the place.

            The available qualities are

1.      good performance

2.      versatility

3.      less expensive

4.      Low power consumption.

 Commonly we can use this for foot dust cleaning.